fractalphreak
Senior Member
- Joined
- Jun 23, 2018
- Messages
- 318
- Location
- United States
- Vessel Name
- Northwest Dream
- Vessel Make
- Davis Vashon 42 Trawler (Defever design)
We have a mix of redundancies, most a work in progress. The two most important, position and depth are complete and almost complete, respectively.
We carry guidebooks and digital copies of the coast pilot. We also carry a mix of paper charts and chart books, but thus far only have our local Washington waters, little in BC or AK - part of our intended long term cruising waters, yet. We have a southern BC trip in July so some are coming soon! I keep the chart book out and open to our current position when we're out, we have a nice big chart table as our dash next to the main help position, its something I've always done, and used to help show the Admiral and the kids where we are and where we are going (and to keep it straight in my head too.) I actually find its easier to look at for overall reference than the plotters sometimes - I don't have a plotter that big! The first thing we do when we think we're going to a place is review available guidebook info on it. Then the charts.
The trawler came with two Garmin 12" MFD's, each with its own independent electronic charts and GPS antennas. Then we added the AIS system and the NEMO onto the NMEA, so we have a third GPS source but only a single point AIS. That brings me to position source #3, the laptop. None of them will work if we have total electrical failure. The lower helm compass is professionally swung since the major electrical install (the inverter installed about three feet below) so in the event of no power to electronics its charts and flashlights and compass. .
For depth I am very short on redundancy right now. We have the Garmin sounder module that feeds both Garmins on their network and the NMEA network (to the Nemo and the laptop.) I have my homemade leadline - a 1 lb blue dive weight with a hook and a line with knots every foot out to 10 ft, then knots at 15 and 20. I think its 25 or so feet long, intended for the shallows only. I have a non-NEMA inside the hull sounder/depth digital depth gauge that I intend to install at the upper helm (if it will reach, not sure yet) to measure depth at the stern for anchoring in bays. Doesn't do any good until its installed and working though.
We're a work in progress!
We carry guidebooks and digital copies of the coast pilot. We also carry a mix of paper charts and chart books, but thus far only have our local Washington waters, little in BC or AK - part of our intended long term cruising waters, yet. We have a southern BC trip in July so some are coming soon! I keep the chart book out and open to our current position when we're out, we have a nice big chart table as our dash next to the main help position, its something I've always done, and used to help show the Admiral and the kids where we are and where we are going (and to keep it straight in my head too.) I actually find its easier to look at for overall reference than the plotters sometimes - I don't have a plotter that big! The first thing we do when we think we're going to a place is review available guidebook info on it. Then the charts.
The trawler came with two Garmin 12" MFD's, each with its own independent electronic charts and GPS antennas. Then we added the AIS system and the NEMO onto the NMEA, so we have a third GPS source but only a single point AIS. That brings me to position source #3, the laptop. None of them will work if we have total electrical failure. The lower helm compass is professionally swung since the major electrical install (the inverter installed about three feet below) so in the event of no power to electronics its charts and flashlights and compass. .
For depth I am very short on redundancy right now. We have the Garmin sounder module that feeds both Garmins on their network and the NMEA network (to the Nemo and the laptop.) I have my homemade leadline - a 1 lb blue dive weight with a hook and a line with knots every foot out to 10 ft, then knots at 15 and 20. I think its 25 or so feet long, intended for the shallows only. I have a non-NEMA inside the hull sounder/depth digital depth gauge that I intend to install at the upper helm (if it will reach, not sure yet) to measure depth at the stern for anchoring in bays. Doesn't do any good until its installed and working though.
We're a work in progress!