Goldenstar38
Senior Member
I have been doing some fuel tank cleaning and was considering adding/making a fuel polishing system.
In doing so, I would like to use the lowest tank fitting where the valve is normally used for the fuel level sight tube. This will be the intake side to the fuel pump and filter. Then, the return side after the filter will be returned through the uppermost fitting where the top of the sight tube was. With 2 added valves, I can retain the sight tube.
Any problems in doing this?
In doing so, I would like to use the lowest tank fitting where the valve is normally used for the fuel level sight tube. This will be the intake side to the fuel pump and filter. Then, the return side after the filter will be returned through the uppermost fitting where the top of the sight tube was. With 2 added valves, I can retain the sight tube.
Any problems in doing this?