1976 Hatteras 58 LRC Stabilizer Install

[mvweebles]

Picture of the Wesmar heat exchanger for my stabilizers. As Sunchaser states, installed in line on the engine raw water intake. 2-inch fittings which has been reduced to 1-inch for my Perkins 4.236 75hp diesel.

Peter

 

[5rnlvqry]

There was some discussion on the wood block mounting and support in previous posts. As discussed, there seems to be different methods for supporting the actuator/fin assembly.

As I was reviewing the NIAID manual last night, ran across a drawing that provides some insight as to the different support methods. See below for some excerpts from the drawing.

Hi James,

I just read your entire stabilizer install thread. Thank you so much for sharing this. Our boat, a KK 48, has a similar setup, and we are experiencing that the fins our not aligned properly. I posted about this yesterday: NAIAD MultiSea II Stabilizer Control System Adjustment. I am looking for a service manual or procedure for adjusting the alignment of the stabilizers. Would you know where I can source one?

Kind regards,

Casey Corcoran