Issue is alignment of the SeaEra (straight 1 1/2") outlet fitting to my sanitation hose. The SeaEra outlet needs to be raised at least an inch for a level (or slightly downhill) alignment with my flexible coupler to my Forespar marelon Y valve inlet. This is not a "plug and play" conversion from a Crown Head (as advertised). I am not able to adjust the location of the Y valve and connections to the sanitation hoses. So, I guess I'm faced with "shimming up" the height of the SeaEra with a with 3/4" plywood base (or more) to raise the level of the discharge fitting to align with the Y valve input barb fitting. I would like to have the connection to the discharge hose be a "downstream" connection so that I don't have waste material collecting and remaining against the joker valve.
Does anyone know of a flexible hose solution (flexible sanitation hose Is not flexible enough) to make a 45 degree bend, outlet fitting to Y valve? Auto heater hose etc.? Lower radiator hose?
Finally, I'd like to know if my old Crown Head assembly has any value. It is complete with parts but inoperative.
Thanks in advance for ideas..
Does anyone know of a flexible hose solution (flexible sanitation hose Is not flexible enough) to make a 45 degree bend, outlet fitting to Y valve? Auto heater hose etc.? Lower radiator hose?
Finally, I'd like to know if my old Crown Head assembly has any value. It is complete with parts but inoperative.
Thanks in advance for ideas..
Last edited: