I need to replace the 1-2 ft section of rubber exhaust just where it begins at my mixing elbow. It got overheated. Operator error. Long story.
Anyway, it was originally installed with a significant bend. When it got hot the bend collapsed. I have cut off the bad spot.
What i want is a 6"od elbow of about 30 degree bend. Then i can get a new piece of hose to connect that to the mixing elbow.
All i see are 90 or 45 degree elbows in either fiberglass or stainless or hose.
Ideas?
--Kevin
Anyway, it was originally installed with a significant bend. When it got hot the bend collapsed. I have cut off the bad spot.
What i want is a 6"od elbow of about 30 degree bend. Then i can get a new piece of hose to connect that to the mixing elbow.
All i see are 90 or 45 degree elbows in either fiberglass or stainless or hose.
Ideas?
--Kevin