HI all. My boat is still new to me, having owned it only 4 months. I'm trying to adjust the clutch on what I thnk is a Maxwell VWC700 windlass. It is installed on an Ocean Alexander 44 and I think it's original equipment. Looking down on it, on top of the capstan is a screw and two holes in the top. It looks like a spanner wrench would fit. Do I turn this to tighten up the clutch? mine won't bring a 45 pound danroth fully into the bow roller.Most of the other windlasses I've seen had slots in the side where I think the clutch handle might go in. The motor runs fine and it brings up the anchor when I deploy it in the slip, but I'm concerned about it's ability to work properly when conditions get rough. Any help would be appreciated.