jefndeb
Guru
Hello,
So Santa dropped off a Noland Engineering RS11 v4 CanBus to NEMA 2K adapter box today...My plan is to use it to send converted Engine Oil Pressure, RPM, Water Temp and Battery Charging Voltage signals to the NEMA 2K bus, via this box. I have a single Yanmar 6LY2AN-STP, which is a pre-ECU version.
Connections dont look bad, basically tie in the signal at the back side of the gauge to the correct input to the Noland unit, and then tweek settings with its calibration S/W via USB connection.
Anybody happen to know where I might could find a spec/reference diagram for these displays?
I dont have any data for these thought somebody might. Their web site didn't show any info.
I attached a picture .
Thanks in advance.
Jeff in Savannah
So Santa dropped off a Noland Engineering RS11 v4 CanBus to NEMA 2K adapter box today...My plan is to use it to send converted Engine Oil Pressure, RPM, Water Temp and Battery Charging Voltage signals to the NEMA 2K bus, via this box. I have a single Yanmar 6LY2AN-STP, which is a pre-ECU version.
Connections dont look bad, basically tie in the signal at the back side of the gauge to the correct input to the Noland unit, and then tweek settings with its calibration S/W via USB connection.
Anybody happen to know where I might could find a spec/reference diagram for these displays?
I dont have any data for these thought somebody might. Their web site didn't show any info.
I attached a picture .
Thanks in advance.
Jeff in Savannah